nosnahc@lemmy.worldcake to 3DPrinting@lemmy.worldEnglish · 11 months agoABL on Ender 3 S1 pluslemmy.worldimagemessage-square9fedilinkarrow-up117arrow-down10file-text
arrow-up117arrow-down1imageABL on Ender 3 S1 pluslemmy.worldnosnahc@lemmy.worldcake to 3DPrinting@lemmy.worldEnglish · 11 months agomessage-square9fedilinkfile-text
minus-squareGoldenSpamfish@lemmy.worldlinkfedilinkEnglisharrow-up3·11 months agoThis can be caused by gantry misalignment/warping, or not registering the bed mesh properly. Also, maybe the bed is warped in some way that was in the middle of the test points, so maybe a finer mesh could fix this.
This can be caused by gantry misalignment/warping, or not registering the bed mesh properly. Also, maybe the bed is warped in some way that was in the middle of the test points, so maybe a finer mesh could fix this.