My prints come out very well but I’m noticing on larger prints that one corner of my bed prints tighter than the opposite. What’s causing this?

Printing on an Ender 3 Pro with upgraded metal extruder, beefier bed springs and metal levelers, and upgraded hot end. Not direct drive yet and no auto bed leveling.

  • XTL@sopuli.xyzEnglish
    3·
    8 months ago

    The soft bed on my old ender 5 had a noticeable wave to it. Levelling it was kind of a compromise. A few areas would end up with more squish than others.

    Actually no bed can ever be absolutely ideally flat and level. As long as you get close enough, it’ll be fine. Print smaller parts on the best area if you can.

    But, like others have said, matrix leveling helps a lot. Which pretty much means getting a levelling sensor.

    • QuarterSwede@lemmy.worldOPEnglish
      3·
      8 months ago

      The print came out great so it wasn’t really an issue. Just more of an exercise than anything else. I am looking at getting a CR Touch. Not quite ready to convince my wife to get a vastly faster printer (and I’m not interesting in investing a lot more time to upgrade the E3Pro to Klipper). I’d rather throw money at the slowness problem and solve a lot more issues at the same time like direct drive, multi color, etc. in future. She’s gotten one functional print she loves out of this one so far so the pump is being primed so to speak.

      Thanks for the matrix advice!