I’m making a homeassistant sever with my raspberry pi and and i’m wondering since it’s going to be on 24/7 that the fans going to wear out much faster than intended. I can’t imagine that I would need a fan ontop of a heat sink and thermal paste it can’t get that hot? I should also note that i’m using an Argon V2 it’s one of those heat sink cases that are made for raspberry pis
You must log in or register to comment.
i like both the argon and the simple heatsink setups, either work great. i did end up adding an additional heatsink to the argon, the flat case does not provide great heat exchange in an enclosed space.
you can do passive cooling as well, just all depends on how hot the location gets.
probably gonna have it on a shelf next to my desk I also have a small bit strong small vornado fan I use to keep me cool. that hits my desk too
should be fine, if you don’t like how warm it gets a set of small heatsinks for amplifiers will run you a few bucks and takes all of 10 seconds to install.
ok thanks
I highly doubt homeassistant will ever abuse the pi4 CPU enough to make active cooling necessary. As long as you have a heatsink of some form on the SoC you’ll likely be perfectly fine. Obviously monitor it for core temps once installed.
Remember the Pi uses the entire PCB copper ground plane in the board as a heatsink too.
I have had some pretty obnoxious recurring reboots on my Pi4 when I don’t add a heat sink and fan.
I’ve been using this after, like you said, 2 weeks of full-time silent 3V fan, leading to a sudden increase in noise and worse performance (it essentially broke), and… damn, it cools even better now, it’s more temperature-stable, and it’s absolutely silent, while no extra power consumption is needed.
It is also true that I try to keep HAOS with as little concurrent addons as possible.
The case is really cool once set up, I love how it feels. It’s got a purpose and it’s going for it. Really feels like it was made 1000% for dissipating heat. And it works like magic.
Most rpi heat sinks have a foam insulator acting as a sticky tape. Remove it and use thermal paste
Why don’t you try a cpu stress test to meausure the cpu temperature with and without the fan ? I think you should try if you’re quite concerned about this.
I used to run a Raspberry Pi 4 in the same case for months at a time and didn’t have issues. I’d say you are fine
Argon case comes with software which controls fan speed and turns it off for temperatures below +50°. My RasPi with HA never went above +45°, the fan inside never turned on. I’m using it for two years now.
