Trying to get this gate to sit level and swing freely. I used an adjust-a-gate kit. The width is 92", height is 6’. I have used the lightest possible wood, and I can’t get this damn thing to hang straight. The turnbuckle that came with it bent straight and came flying out of the holes, so I used a different one I had on hand. Clearly the wheel isn’t doing anything except causing the gate to warp since it isn’t centered under the weight.
I want to add a diagonal cross brace from the bottom hinge to the top corner, but I’m not sure how exactly to do it with the 3 horizontal boards.
I’m also considered replacing the hinges with 3 extra long strap hinges, one on each horizontal board.
What do you guys think?
I really appreciate this comment. I was hoping that using the thin cedar pickets would have been enough to keep it light. I’m not averse to redoing the gate at some point, or even tearing our the gate posts and using 6x6 posts ajd putting them even deeper, but right now I just need to get these things up and working.
I just don’t know how to add the diagonal brace board with the middle support board in the way.