• phant@lemmy.world
    link
    fedilink
    English
    arrow-up
    20
    ·
    9 months ago

    This was the info I was interested in.

    Finely ground (espresso) coffee grounds were dried in the sun and then sifted. Then mixed with binders (xanthan gum and carboxymethyl cellulose powders) and water. These are printed in a modified consumer grade fdm 3d printer using a syringe instead of the hot end. The resulting material is claimed to be as strong as unreinforced concrete, but is biodegradable.

    • Overzeetop@lemmy.world
      link
      fedilink
      English
      arrow-up
      11
      ·
      9 months ago

      I’d be curious what their measure of concrete is. The plain stuff has 3000psi compressive strength and a usable modulus of rupture of around 250psi. And if it survives re-wetting / over-drying and aging.

      PLA is (very) roughly 20x that.

  • callcc@lemmy.world
    link
    fedilink
    English
    arrow-up
    3
    ·
    9 months ago

    The cups look coated from the inside. Interesting but definitely not groundbreaking. I’m looking into printing with biopolymers using a syringe. I’ts interesting also because it needs way less power since no heat is needed.

  • Fly4aShyGuy@lemmy.one
    link
    fedilink
    English
    arrow-up
    1
    ·
    9 months ago

    Very cool, I’m hoping to get into 3D printing and make probably more than my fair share of coffee grounds in a week haha!