I changed the strings on my Jackson Dinky JS11. Normally I use light gauge, but this time I went with medium. After tuning it and noticing the difference in thickness, the bridge is on a sharp angle, and the whammy bar couldn’t even swivel past the volume knob.

I tried loosening the two bridge screws which helped a bit and raised it to be less sharp of an angle, but it also raised the action considerably. At least the whammy bar can swivel freely. But the amount I can “wham” seems less than before, too. (Pictures are after this adjustment)

Is there a way to get the back end of the bridge downward so it is more “even”? That would reduce some of the action and give me more whammy room?

  • eezeebee@lemmy.caOP
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    I’ve tightened them to the point they’re practically flush so I can’t go further. And yeah, tight springs are scary to begin with.

    • DarkInspiration@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      Did you loose the tension on the strings as you were tightening the screws? Because that also matters in order to balance the tension

      • eezeebee@lemmy.caOP
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        I have now, after the fact. Still not much difference on the bridge angle.