When you make something that’s too big for your printer, how do you hide the seams from bonding when aesthetics are a priority?

  • GTKplusplus@kbin.social
    link
    fedilink
    arrow-up
    6
    ·
    1 year ago

    I use a fair bit of 5 minutes epoxy, and try to make the mating parts have some sort of keying and registration, with both help with alignment and with strength of the joint.
    Then I go over the seam with a sharp knife/chisel to remove any squeezeout and blend it.

    After that, it’s a whole lot of using putties, filler primer and sandpaper to get it smooth and hiding all the signs of it having been 3d printed and assembled.