I’m in Austin Texas. We installed a fence three years ago and the posts between the gate door have shifted about four inches. This makes closing the door a pain in the ass, as the latch quickly becomes misaligned. A few times a year I move the latch bracket down to align it with the other part of the latch. My fence post is full of holes, and along with the constant slamming necessary when it gets out of line, it has started splitting.
How do I end this cycle? How do I keep it from moving so much?
Theyre all wooden posts, set in cement. I don’t know how deep though… We hired someone to do it. They are definitely moving vertically, but I don’t think there’s any wobble from side to side… The latch is locking, and it’s about two inches tall, but it is always in line in the y axis, it just goes off up and down. Not sure if it’s both sides moving, but I know the gate is now also hitting the cement holding the opposite post.
Pics would help for sure, I’ll get some tomorrow.
If they are moving vertically it sounds like the ground under them is subsiding. Either that or it’s being removed. Is the whole fence doing this or just one or two spots.
Now that I take pics I see the latch side is leaning, which makes sense, since the whole fence is probably settling and pulling it.