Temperatures recorded in the oven during a dutch oven sourdough bake. 20 minutes at 500F with the dutch oven lid on, 20m at 400F with it open.
Green = oven temperature throughout. Blue = baseline kitchen temperature (thermocouple cold junction temp).
- Before 1st blue line: preheating. Yellow line = inside a cold cast iron dutch oven. Oven was already warm from baking something else.
- 1st blue line to 2nd: baking with lid on. Yellow = probe in the loaf here onward. I was surprised the internal temperature has pretty much maxed out by the end of the first 20 minutes.
- 2nd blue line + 20 minutes: baking with the lid off.
- After 20:27 / green line dropoff: oven open, loaf cooling. I know you’re supposed to cool to “room temperature”, but even at 150F the crumb was pretty stable when I cut the loaf, with no obvious tearing or sticking to the knife.
Compare to the previous bake where I forgot to reduce the oven temperature after the first 20 minutes. The crust was black/inedible, but the interior was still totally fine.
If you know of an appropriate high temperature humidity sensor I’m listening! I don’t see one though.
The cheapest way to do it would be to have a sample line connected to the Dutch oven (metal line) that’s attached to a dog-eared beaker (with rubber tubing), with the other ear of the beaker being a line attached to something pulling a vacuum (like those vacuum nozzles in chem class connected to the sink outlet). You then place this beaker on a hotplate that keeps it warm (so you don’t condense on the glass) and you have a stainless steel cylinder with a rubber outer stopper ring thingy (to seal the beaker). You heat some water to say 190 (I doubt your dew Point is above this temp lol) and then add it to the cylinder. Place a thermocouple in the cylinder and blow air lightly into the tube to lower the temperature. When the cylinder fogs, you have the dew Point temperature of the atmosphere from within the Dutch oven.
Source: This is the same process for getting a dew point of your furnace atmosphere in an industrial setting. The concept is known as a “chilled mirror” dew Point. There are continuous devices that can determine this, but the manual method is cheaper/can withstand higher dew points
If you went for a method using a digital hygrometer, you would still want a sampling line that goes from the Dutch oven, to outside the oven because I’m not aware of any hygrometers that would work in intense heat unless they had their own cooling jacket + cooling system for the mirror & sensor
note: I am trying my best to get a picture of this setup, we use them at work, but searching online is mostly returning inline, digital hygrometers
Edit: Okay, I drew it instead on a sticky note. When the cooling water in the tube makes it fog, that temp on the thermocouple is your dew Point