😈😈 Finally an advantage to using rEFInd 😈😈

Thanks. I’m still learning how Lemmy works 😅

Why is that?

Can you give some examples 😅

I’ve read the “learn more” bit now and I’m going to leave it switched on. (although I use uBlock anyway ‍😅)

I think this is a legitimate attempt to ‘fix’ the internet. It seems only very basic information on interactions with ads is recorded by the browser, and then it is anonymised. As an example, the advertiser should only receive counts of how many people bought a product after seeing a particular ad. I don’t think they can see what webpage anyone in particular came from, but maybe they can see that: 11% percentage of visitors came from example.com/some-page

Presumably the anonymised data is only provided once the pool is fairly large and wouldn’t show 100% of visitors came from cornhub when you only had one visitor 🤷‍♂️ Obviously websites will always see an IP address.

The idea is for this to substitute for traditional, more invasive, tracking. I think it may one day achieve that.

A warning though: I only just started reading about this.

Excuse me while I go and click that ‘learn more’ button…

I’ve had the same thing. I think orca’s retraction test is just too ‘easy’. I think the towers are too far apart.

A ghost 👻

I can see a bit about the solid state relay overheating with too much power, but that’s not the bed. Have I missed something or have you possibly misread something yourself 🤪

I don’t know how small you are thinking, but if it’s V0 size, make sure you’ve seen the “crucible” on 3dprintersforants, it looks cool 😎

I don’t think anyone has a v0.2 in this instance 😅 Thanks for going out of your way to answer my question, even though you can’t 🤣

I’m wanting it because I realise I do a lot of very small parts and I often want to iterate on them quickly, so a fast bed heat would be quite nice. I currently always heat soak for bed meshes and such, but I haven’t found it necessary for prints - they’re usually not that big though 🤷‍♂️

Do you know where I can find that documentation on max heating?

Thank you 😁

That’s extremely helpful, and I didn’t even expect a reply after this time.

How many watts is the heater you are using?

I’m thinking of buying a used 0.2 and I wondered if it might be fun to change to an AC bed. I read the original v0 had one but some kits were using improper solid state relays so they changed it for safety 🧐

I certainly see you the chamber heat argument for ABS 💪

Why do bed slingers heat faster?

💪

You can’t trust what you can’t see.

This was it! I had my 10-25% (not degrees 😅) overhang speed set not to slow down at all. I now have it set to 30mm/s and I have a perfect result. Thank you 👍😁

Sorry, I didn’t follow that. Top layer of what? Not the actual top, top layer right?

You may actually be right even though I thought I had checked this. Orca’s overhang speeds are based on overhang percentage and not angle, I previously just looked at the number and assumed it was degrees 🤦‍♂️I will match the speeds for all overhang percentage ranges and see if that solves it 🤞

Thanks. I’ll experiment with temperatures first but I’ve got some different filament on the way too as it happens, so hopefully I’ll manage to escape the problem one way or another 😁

Thanks, I’ll give it a go.

It starts just underneath actually, but it still could be related 🤔 Maybe I need a test without numbers.

Thanks guys. I will try both and see what works. My layer adhesion is good / parts are strong though.