Telegram group STL

Don’t have the link but do remember it is easy to find threw Google

Don’t know if it still work that way but once you are in cinemaz, you will see notification from time to time when avistaz has open sign-up. Also red for music is good, sign-up is (or was) threw interview. Not difficult if you know basics of torrent/ripping but ratio isn’t easy to maintain.

D’une certaine façon, je trouve ça pas plus mal qu’il y ait moins de gens. Ça fait moins de troll et les gens sont plus détendus je trouve.

I download comics/manga then buy paper version to support author. I wish every authors would have patreon, PayPal or else so I can give a bit more to author directly as they are getting crushed by editors.

Sending you the sandman (hope that’s proper wording) right away. Happy sleeping ;)

Thanks for the detail answer

Thanks for your reply

26gb,4k DV is enough unless you are looking for remux

Something like this? https://cults3d.com/en/3d-model/various/needle-disposal-system

If you want it free, you should selfhosted it

You would also need a computer with your 3d printer as you just don’t feed printer with files from internet. (Actually, they are a few case where you can but it is very limited). As for your question: To save money, you need to earn money…

Can’t talk for the price but you won’t find an other company that match as much your requirements, only issue with prusa mini is the small print area but depending what you want to do, it can be enough.

Do you have on of those plastic extruder? If so, check for a crack (dismantle to check everywhere).

Could also be wrong estep (take Bowden off, cut filament after extruder, extrude 10cm and mesure to see if accurate)

Or maybe a partial clog.

Also check your flow settings in slicer.

Chances are you are squishing too much first layer, so adjust that first. Then print over residue with slow speed and 5-10° hotter than usual settings. Residue should come off with print.

archive.org is one. But keep in mind that your address will still be seen whatever torrent site you use unless you are hiding behind vpn.

Got one of this for about 2 years and it is working well. Did you try to adjust spring tension? Also, 20$ is too expensive for those. They cost about 10$